Description
Our Jeep TJ shock tower bundle puts our front and rear coilover towers in one order. It fits the TJ and LJ, and it’s built around a 2.5″ coilover or ORI strut.
So whether you’re doing a coilover conversion or a full 1 ton swap, both ends match. Pick the rear towers with or without the bump mount add-on. Every tower is laser cut, CNC bent and Made in the USA.
What’s in the Jeep TJ Shock Tower Bundle
Each part is the same one we sell on its own. Here’s what goes in the box.
- TJ Front Shock Tower. These towers straddle the factory front frame rails. As a result, fitment is easy and the frame gets stronger. Each tower sits about centered on the frame, so the shock gets room and a proper angle. It also clears the factory steering shaft. You get left and right uprights, tops and shock tabs, plus our 1/2″ teardrop capture washers.
- TJ Rear Shock Tower, your pick of two. Each tower frenches 1 3/8″ into the frame. That makes room for up to a 2.5″ coilover or ORI while clearing 40s flexed out. Plus, you only notch half the frame.
Pick Your Rear Towers
- Towers only. You get left and right uprights, left and right tops and four inner shock tabs.
- With the 2.0 bump stop mount. You get all of the above, plus left and right bump can saddle mounts. It also adds left and right frame french gusset plates and two limit strap frame tabs.
Since the rear shock mounts off the back of the axle, the space over the axle stays open. So you can french a bump stop into the frame. It also lets a sway bar run in front of the axle. On the bump mount version, the limit strap tab doubles as a gusset for the bump mount.
Coilover Towers Built for 2.5″ Shocks
Only one of the two shock tabs on each tower keys into place. So you set the spacing you need, whether that’s 1.25″, 1.5″ or 1.6″ for ORIs. The front shock tabs also use our captured weld washers for added strength.
Here’s a tip for the front towers. Weld the shock tabs to the top plate first, then weld the top plate to the upright. That makes finish welding a lot easier.
Clean Parts, Ready to Weld
Every part runs through our wide belt sander before it ships. That means no slag and no mill scale on your parts. So they show up clean and ready to weld, prime or paint.
TJ Shock Tower Bundle Fitment and Install Notes
This bundle fits 1997-2006 Jeep Wrangler TJ and 2004-2006 LJ models. All towers are 3/16″ steel and ship unwelded.
- Rear body lift. We designed the rear tower around a 1″ body lift. It’s recommended but not required. Without one, mount the tower 1″ lower or trim the inner fender.
- Welding. Plan on welding and fabrication for this bundle. So only tackle the welding yourself if you’re an experienced welder.
- Fitment. Expect some grinding and fitting during install.
Want more strength up front? Then tie the front towers together with our TJ Front Shock Tower Brace Kit. That way, you get a removable cross brace. For the axle side, see our Lower Link Bracket with Shock Mount or Offset Axle Shock Mount.
Shocks, coilovers, bump cans, the sway bar and its mount are sold separately. The towers can’t ship to a PO box, so please use a street address. Offroad Anonymous is not liable for improper installation.










